2. After separating the Speed Sensor coupler, plug in both the male and female 3-pole GFY harness connectors. Make sure the connectors are fully seated.
3. Find the 2-pole natural (or black) color plug of the Crankshaft position
sensor (Pickup coil). It has two wires coming from the crankcase: one is Gray, the other is usually Black/Blue - check the colors at both sides of the plug (if in doubt, do a temporary connection e.g. by using a thin needle to backprobe the connector pin). The 2-pole connector is usually under the fuel tank.
for XVS1100 models only: find and use the Orange (ignition coil wire).
Some Model Need To Find the 2-pole plug of the AC magneto (Crankshaft position sensor/Pickup coil). It has two wires coming from the crankcase: one is Red, the other is usually White
4. On the wire identified in the previous step, peel off the black sleeve (tape) near the 2-pole plug, leaving about 3 cm (1.2”) of the wire exposed.
5. Connect the GFY Black/Green wire to this bike wire, using the Red wire tap connector supplied.
Usage: Place the unstripped bike wire inside the run channel. Close the side cover until latched. Cut off the excess length, then insert the unstripped tap wire (Black/Green) completely and check its position. Insert the blade (u-contact) and press down by finger pressure. Then, fully depress the u-contact with pliers. Close the hinged top cover until latched.