First step:Dry with a dry rag Moldy surface
Second step:Completely cover at least 3mm moldy surface like a toothpaste
Third step:Wait 4-8 hours No water in case of heat Wrapped in plastic wrap
Fourth step:Until no mold is visible With water and rag Scrub clean
Stubborn mold waiting for more than 12 hours If it is not clean once, use it at least 2 times.Until the mold is completely removed!
1.Keep indoor ventilation before use, wipe the moldy black surface with a rag, and the wet
environment willAffect the gel effect
2.To prevent the gel from hitting the hand when using it, you can wear rubber gloves.
3.If you are very sensitive to a little smell, you can wear a mask.
4.completely covered with moldy toothpaste at least 3mm in moldy black, do not wipe thin
5.Prevent gel flow, can be fixed with plastic wrap, the effect is better
6.Do not encounter water during the smear waiting for heat to prevent deformation
7.waiting time can be extended to more than 12 hours and even longer, until the mold
8.If you encounter stubborn mold, do not remove it once, wipe it clean and repeat the
9.After use, wipe the residual gel with a paper towel and rinse with plenty of water.
10. Gel is not used to remove yellow stains. Tiles on the yellow are recommended to use
11. Some glass glue is moldy inside, the mold remover can not penetrate the bottom of the
glass glue, suggesting tools Remove the glass glue, then use the mold remover, the new
12. mold remover can only be used for PVC wallpaper, non-woven fabric and any cloth
material only white Can be used
13. high temperature, freezing or direct light will reduce the viscosity of the product,
must be covered after use In a cool and dry place, it is best to use it within 6 months
14.Invalid use of discoloration or contamination by metal components, do not touch colored
15.Note that mold and gel are prohibited for aluminum products!